Fuerst FB42, Operator'S Manual

Page: 55 / 82

OPERATION
OPERATION
Operation Section 4-29
© 2004 Alamo Group Inc.
FB42 08/01
13. TRANSPORTING THE TRACTOR AND MOWER
Before transporting the tractor and mower, idle the
tractor engine, disengage the PTO and wait for all
mower moving parts to come to a complete stop. Once
all mower parts are completely stopped, raise the mower
to transport height. NOTE: When raising the mower,
maintain 1” clearance between the driveline and mower
deck. If additional mower deck height is needed for
safe transport, disconnect the driveline from the tractor
and secure its end to the mower deck. The mower can
then be raised to the maximum lift height.
If the tractor’s hydraulic pump is not independent of
the tractor PTO, or if the tractor PTO has to be run to
have hydraulic power, disconnect the mower driveline
from the tractor PTO output shaft. Secure the driveline
to the mower deck to prevent driveline damage or loss
during transport.
Inherent dangers of operating the tractor and mower and the possibility of accidents are not left behind when you
finish mowing an area. Therefore, the operator must employ good judgement and safe operation practices when
transporting the tractor and mower between locations. By using good judgement and following safe transport
procedures, the possibility of accidents while moving between locations can be substantially minimized.
DANGER!
Never allow children or other persons to ride on the Tractor or
Implement. Falling off can result in serious injury or death.
(SG-10)