4
STEP 2:
1.
Install Handle Bar (3) on Console Mast (2) and lock with Quick Release lever (19).
Install the Hand Pulse Cable (82) through the console mounting plate as shown
below.
2.
Connect Computer Cable (80) and Hand Pulse Sensor Cable (82) to the Console
(48) and assemble on the Console Mast (2) using Phillips Head Screw Driver (43)
to tighten 4pcs of M5 × 12L Phillips Head Screws (41).
3.
Use 15m/m Wrench (79) to install both Pedals (15 left and right) on the crank axle.
The left pedal is a reverse thread and will screw in a counterclockwise direction.
The pedals are marked with an R or L on the end of the threaded pedal axle. Make
sure to tighten the pedals firmly or a clicking noise can occur during pedaling. It
may be necessary to retighten the pedals after use if clicking occurs.
4.
Locate the 3/8" ×
1-1/2"
Carriage Bolt (71) and assemble through Seat slide
bracket (20) and seat tube Slide (6). Secure the slides with 3/8” Flat Washer (72)
and
fore/aft adjustment Knob
(52).
Summary of Contents for FUEL BIKE 4.0
Page 18: ...17...
