11
Note:
If your Pulse measurement is above or below (± 5) the TARGET H.R setting, the
computer will adjust the resistance load automatically; it will check approximately
every 10 seconds. If the heart rate signal disappears, the computer will keep the
resistance load constant for 60 seconds then it will decrease the resistance load 1
level every 10s.
When any One of the workout parameters counts down to zero the console
emits a beep sound and the workout stops automatically. Press START KEY to
continue the workout to reach the unfinished workout goals set.
Wearing The Chest Strap
(Sold Separately)
1.
Attach the transmitter to the elastic strap using the locking
parts.
2.
Adjust the strap as tightly as possible as long as the strap
is not too tight to remain comfortable.
3.
Position the transmitter with the logo centered in the
middle of your torso facing away from your chest (some
people must position the transmitter slightly left of center).
Attach the final end of the elastic strap by inserting the
round end and, using the locking parts, secure the
transmitter and strap around your chest.
4.
Position the transmitter directly below the pectoral
muscles.
5.
Sweat is the best conductor to measure very minute heart beat electrical signals.
However, plain water can also be used to pre-wet the electrodes (2 ribbed oval areas on the
reverse side of the belt and both sides of the transmitter). It’s also recommended that you
wear the transmitter strap a few minutes before your work out. Some users, because of
body chemistry, have a more difficult time in achieving a strong, steady signal at the
beginning. After “warming up”, this problem lessens. As noted, wearing clothing over the
transmitter/strap doesn’t affect performance.
6.
Your workout must be within range - distance between transmitter/receiver – to achieve a
strong steady signal. The length of range may vary somewhat but generally stay close
enough to the console to maintain good, strong, reliable readings. Wearing the transmitter
directly on bare skin assures you of proper operation. If you wish, you may wear the
transmitter over a shirt. To do so, wet the areas of the shirt that the electrodes will rest upon.
Summary of Contents for FUEL BIKE 4.0
Page 18: ...17...
