are using, an effects loop device may not be needed. You can try any unit you like, and
see if the tone and performance is acceptable to you without damage to the unit.
Footswitch Jack:
This is a stereo ¼” phone plug. The tip is overdrive select, and the ring activates a gain
boost, which does not disable tone controls, and works on both clean and dirty
channels.
6
Biasing the amplifier power tubes & other technical info
The circuit board is shown earlier in the manual with the chassis sitting on its
transformers, and front panel facing you. There are exposed high-voltages in this
chassis, even with the amplifier shut-off! If you are not familiar with tube amplifiers
and/or high voltages, do not attempt to remove the chassis from its cabinet or to
attempt to service this amplifier. Refer servicing to the factory or to someone with
experience servicing these types of amplifiers.
DISCLAIMER:
There are exposed high-voltages within this amplifier. Do not attempt to
service, repair or conduct tube biasing unless you are qualified to do so. Please contact
Fuchs Audio beforehand with questions in this regard. Fuchs Audio takes no
responsibility or shall be held liable for any personal harm caused or damage to this
amplifier as a result of unauthorized service, repair or internal adjustments
made to this amplifier.
FCC COMPLIANCE STATEMENT: This equipment has been tested and
found to comply with the limits of Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna. •Increase the separation
between the equipment and receiver. •Connect the equipment into an outlet
on a circuit different from that to which the receiver is connected. •Consult
the dealer or an experienced radio/TV technician for help.
