OD-tone:
The OD tone control is a simple high cut control which allows you to go from “woman
tone” (full counter clockwise), to D-style (center 30% range), to rock/English tones (full
clockwise).
Reverb Level:
The Reverb level control adjusts the amount of reverb return to the amp.
Reverb Decay:
The Reverb decay adjusts the time it takes for the reverb signal to decay.
Counterclockwise is the shortest decay, and turning all the way clockwise increases the
decay time.
5
REAR Panel Controls, inputs/outputs
AC power cord input:
Using a standard IEC power cord. Connect to AC POWER IN on the amplifier and to AC
power source. Please note the voltage on the chassis, and make sure you are supplying
the correct AC voltage to the unit. Damage from incorrect voltages is not covered by
warranty.
AC power Fuse:
This fuse protects the amplifier if any malfunction occurs. Use ONLY the stock fuse
rating as supplied by factory and shown on the rear panel for the voltage and current in
your location.
Speaker outputs:
4, 8, 16 ohm outputs. Use the same impedance as the speaker you are using for
maximum power and performance.
Standby/Play switch:
Up is play mode. When amp is not being used, but being warmed up, place amp into
standby mode.
Effects Loop Patch jack:
This is a stereo ¼”. The tip is the return to the power amp. The ring is the send from the
preamp. This may be used with an outboard effect loop like the Plush Tube FX loop, or
various other aftermarket devices for this purpose. Depending on the outboard unit you
