“2
Please read before powering up your amplifier.
Please see Panel Diagrams in next section 3 for assistance.
1)
Inspect to make sure power & pre-amp tubes are intact & snuggly seated in their
sockets.
2)
Make certain a speaker (load) is plugged into speaker input jack on the back of
the amplifier. Failure to have a speaker connected to the amp will result in
damage to the output tubes! Your amp is supplied with 4,8 and 16 ohm speaker
output jacks, select the one which matches your speaker(s) impedance.
3)
Reduce Front panel GAIN controls to moderate level.
4)
Install instrument cable from guitar into front panel INPUT
5)
Be sure both POWER switch (front panel) is in DOWN (0ff) position and standby
is in off (down) position.
6)
Install power cord to amplifier (AC POWER IN) and to appropriate AC power
source.
7)
POWER UP amplifier by: 1) flipping POWER switch UP. Allow at least 30 seconds
to 1 minute for tubes to heat up. Then switch amp to operate mode via standby
switch.
8)
The Amplifier is now fully on and ready to use. Feel free to adjust all controls as
you see fit.
9)
Provide adequate and unimpeded ventilation.
10)
Do not expose the unit to drips or splashes.
11)
Do not to place liquids on the unit.
12)
Properly ground the unit (i.e. make sure the outlet used is grounded, and ground
is not defeated between the outlet and unit).
