Fubag WHS 190 DC, Operator'S Manual

Page: 13 / 27

- 12 -
8. Trouble Shooting
www.fubag.ru
O m perator's anual
When welder engine fails to start after several attempts, or if no electricity is available at the output
socket, check the following chart. If your welder still fails to start or have no electricity, contact your
nearest welder dealer for further information or corrective procedures.
When Engine Fails to Start:
When No Electricity Is Generated at Receptacle:
Check if choke lever is in its
proper position
Check if fuel cock is open.
Check fuel level.
Check to make sure generator is not
connected to an appliance.
Check spark plug for loose spark
plug cap.
Check spark plug for contamination.
Remove spark plug and clean
electrodes.
If loose, push spark plug cap
back into place.
If connected, turn off the
power switch on the connected
appliance and unplug.
If empty, refill fuel tank making
sure not to overfill
If closed, open fuel cock.
Set the choke lever to
"CLOSE" position.
Check to make sure no-fuse breaker
is in the ON Position.
Check DC terminals for loose
connections.
Check the appliance or equipment
have any defects .
After making sure that the total
wattage of the electrical appliance is
within permissible limits and there are
no defects in the appliance, turn the
circuit breaker to the"ON"position. If
breaker, continue to actuate, consult
your nearest servicing dealer.
Secure connections if necessary.
Replace or repair it.