Fubag PG 950 T, Operator'S Manual

Page: 9 / 25

- 8 -
Switching off
O
Rinsing
Safety features
1.
2.
3.
1.
2.
3.
4.
5.
6.
7.
8.
Restore the gas lever to its original position.
Set the engine switch to the “ ” position. The motor pump stops.
Drain the motor pump then rinse it if its use is over for the day.
Once the motor pump is shutdown and cold:
Empty the suction & discharge hoses, allow the liquid to drain out.
Unscrew the drain plug from the pump in order to drain-out the pump housing.
Screw the pump drain plug back on once drainage is complete.
Remove the pump filler plug and fill the pump housing with clean water.
Slowly pull the recoil starter handle several times till encountering resistance, allow it to return
back gently.
Unscrew the pump drain plug and drain the pump housing.
Screw the pump fill & drain plugs back on.
Clean the strainer.
If there is no oil in the engine sump or if the oil pressure is low, the oil safety mechanism
automatically stops the engine to prevent any damage. If this occurs, check the engine oil level and
top it up if necessary before looking for any other cause of the problem.
www.fubag.ru
O m perator's anual
6. Maintenance
This section describes how to service the .
Servicing and repair work not described in this section must be carried out by the manufacturer’s
personnel.
The following servicing work must be carried out in accordance with the corresponding periods.
pump
Component
Operations to be
carried out at
whichever
deadline is
reached first
Each time it is
used
First month
or after the
first 20 hours
3 months or
Every 50
hours
6 months or
Every 100
hours
12 months or
Every 300
hours
Check the level ·
Engine oil
Change
· ·
Check ·
Air filter
Clean ·
Motor pump Clean ·
Strainer and
Sediment bowl
Clean ·
Spark plug Check / Clean ·
Valves * Check/adjust* · *
Fuel tank* Clean* · *
Fuel line*
Check (replace if
necessary)
Every 2 years*
* Operation(s) must only be carried out by one of our agents.