- 5 -
Charge of several batteries simultaneously
Several batteries can be charged simultaneously by connecting
them in parallel (the “+” terminals connected to the red clamp and
the “–” terminals connected to the black clamp). These batteries
or grouped batteries must be at the same voltage 12V or 24V.
- Do not unplug the battery from the vehicle. If the battery is unplugged it can lead to information
being lost and eventually impossibility of starting the vehicle.
Do not connect to the mains at the beginning.
A pre-charge may be needed in order to provide the energy indispensable for a start. Please refer to
the following table :
DRIVE 430/24
DRIVE 610/24
- Place the switch of the machine on STOP
- If a pre-charge is necessary: Place the selector at the following position:
- Connect the red cable on the “+” DRIVE terminal 12V or 24V depending on the voltage of the
battery.
- Connect the “+” red clamp to the “+” battery terminal; and the “–” black clamp to the “–” battery
terminal making sure you get a good electrical contact.
- Connect the DRIVE input to the mains (220V 50Hz).
- If a pre-charge is necessary: Place the selector on the charge position for about 10 mins.
- START: Switch to start without disconnecting the input from the mains. Never try to start in
CHARGE position.
The charge in serial is not recommended.
U
n starting mode (START)
Prior precautions
Connecting and unplugging
se i
- Go to the control seat of your vehicle. By ignitiating, you will activate the starter function. If needed,
reiterate the operation.
If the engine is not starting, restart a complete cycle (pre-charge, start).
DRIVE 430/24
DRIVE 610/24
www.fubag.ru
O
m
perator's
anual