Temperature and Humidity Sensor
Page 9/15
700-THS3 Rev. 6 -05 May 2015
Chapter 3
Sensor Quick Setup Guide
This chapter will take you through the steps to set up (configure) the THS3 with an Axiom datalogger.
It is meant as a quick reference. Detailed instructions can be found in the Axiom User Guide and
Axiom Configuration Reference.
NOTE:
After installation, the sensor should be given a minimum of thirty minutes to
acclimatize to a site before data is taken.
3.1
Configuring the THS-3
1)
Connect the THS-3 to the data logger on the red Temperature and Humidity port.
2)
From the data logger’s home page, select the Sensors icon.
Figure 3-1: Home Page
The next screen (SDI Sensor Mapping) will display the icons of the dedicated sensors which
are already added and set up.
3)
To add the THS-3, select the Add icon, then press on the Air icon.
Figure 3-2: Adding the THS-3
