9
Before installation/maintenance, the tractor and mower should be
stationary with the hydraulic lift system in a neutral position and
the ignition key removed.
To increase the blade clearance and cutting height for rough ground or
long grass, either raise the tractor
’
s hydraulic lift arm or adjust the rear
roller and skids on the mower.
Rear Roller Adjustment:
1.
Loosen bolt (
2)
2.
Remove bolt (
1)
on both sides of the mower.
3.
Adjust the roller by aligning the selected hole in the roller support
bracket at position (
1)
. (Using the hole closest to the ground gives
the highest working height).
4.
Put bolt (
1)
into the selected hole and re
-
tighten bolts (
1)
and (
2)
.
Setting cut height
Skid Adjustment:
Loosen bolts (
3)
on the skids (front and back on both
sides). Move the skids up or down to the desired height. Re
-
tighten bolts.
3
10
Drive Belt Adjustment
Before installation/maintenance, the tractor and mower should be
stationary with the hydraulic lift system in a neutral position and the
ignition key removed.
To achieve the correct belt tension, the belt must be deflected by the belt
thickness approx. 1cm at the centre point between the pulleys. Always
align the gearbox so the PTO drive shaft is parallel with the body. Use a
straight edge to ensure the belt pullies are inline and running true.
