3
Safety Information
Before installation/maintenance, ensure tractor and mower are
stationary with the hydraulic lift system in a neutral position, and
the ignition key removed. Read and understand this manual fully
before operating machinery. Failure to follow all safety standards
can result in severe injury or death.
1.
Regularly check condition of/service both tractor and mower.
2.
Regularly check/tighten all bolts, nuts and screws.
3.
Never consume alcohol/drugs while operating machinery.
4.
This mower is for use with compact tractors only, within the power
range specified, and at the recommended speed at all times.
5.
Always keep the PTO output from the tractor at 540 rpm. Reduce the
speed when working on hillsides/rough terrain.
6.
Only use for the indicated purpose. Do not use to transport
personnel or livestock.
7.
Always wear protective gloves, ear and eye protection and tie back
long hair. Do not wear loose clothing.
8.
Always check the immediate area is clear before operating. Check the
cutting area is clear of debris that can cause equipment damage.
9.
Keep spectators at a safe distance.
10.
Do not run the engine in an enclosed area.
11.
Do not leave the machine unattended while operating.
12.
Do not touch moving parts. Keep hands and feet away from rotating
blades.
13.
Stop the engine if excessive vibration occurs.
14.
When travelling, keep the PTO turned off and the mower in a
transport position.
15.
Ensure the engine is switched off before any maintenance. Be aware
components can be hot after operation.
16.
Pay attention to any sharp/pointed parts when servicing.
17.
Always repair/replace any defective parts.
18.
Do not modify the mower in any way as this may impair the
operation and overall safety.
19.
Ensure all safety guards are in place and in good condition.
20.
Keep all safety signs clean and legible. Replace missing/illegible signs.
4
Safety Information (continued)
Mower Pre
-
use Checks
Upon receipt of your new mower and again within the first 4 hours of use
(the
‘
shake in
’
period), we recommend the following:
1.
Check/tighten all bolts, nuts and screws (and those securing blades).
2.
Check the tension of any belt(s), and adjust if required.
3.
Apply grease to grease points if required.
4.
Check gear oil level, top
-
up if required but do not overfill.
Be aware components can be hot after operation.
Tractor Pre
-
use Checks
1.
Check the mower is properly attached to the tractor. Ensure secure
pins are used on the linkage mounting pins.
2.
Add extra weights to the front of the tractor (or wheel weights) if
required.
3.
Check the tractor PTO turns freely, and the mower
’
s PTO drive shaft
can extend sufficiently. Apply grease to the PTO drive shaft.
4.
Frequently check the condition of the chain on the PTO drive shaft.
Keep all universal joints and protective parts in a good condition.
5.
Before installing, the tractor and mower should be stationary,
remove the key from the ignition.
6.
Install and secure all safety guards, doors and covers before
operating.
7.
Bystanders should leave the immediate area before connecting the
drive from the tractor.
Post
-
use Regular Checks
1.
Check blades, belts and wearing parts. Ensure they are not damaged
and blades are secure in their mounts. Repair or replace as required.
2.
Clean the mower, and check for/clear any entangled material around
any moving parts.
