FSR MAS-7000, Installation And Operating Manual

Page: 13 / 52

13
MAS-7000
Your unit can handle a very wide array of inputs and convert them all to a single output signal with de fi ned
characteristics. This output resolution will remain in place until changed. The top line of the display will show
the current output resolution selected.
Output Adjust Output Adjust
HDCP [ON OFF] HDCP [ON OFF]
HDCP is a ‘High-bandwidth Digital Content Protection’ system, which can ensure that a high de fi nition video
signal cannot be received by units not equipped with a HDCP receiver. This menu lets you see the current status
of the output and whether HDCP is supported or active, and also lets you turn off the output’s HDCP encryption
system. Note, however, that turning HDCP off at the output will also prevent HDCP-encrypted signals from
being received by the unit –see the table below. By default, HDCP on the output is turned On -so that if your
attached DVI display is HDCP-compliant, then your output will be encrypted (regardless of whether the input to
the scaler is encrypted). Note that you don’t have to attach a display to the output of the scaler –another unit can
be connected instead, in which case that unit is known as a ‘repeater’. Please also see the HDCP menu item in
‘Input Adjust under DVI-D’, as this controls availability of HDCP at the DVI input. The status message given in
brackets has the following meaning:
Status
message Description Effect
No display There is no display attached
(HOTPLUG is low). Nothing will be output on the DVI connector.
Unavailable The device attached is not
capable of support ing HDCP. As the DVI output cannot be HDCP encrypted, then
a HDCP-encrypted source cannot be selected for
scaling.
Supported The device attached is
capable of HDCP, but the
output is not currently
encrypted. As the DVI output is not HDCP encrypted, then a
HDCP-encrypted source cannot be selected for
scaling.
Active The device attached is
capable of HDCP, and the
output from the unit is
encrypted. As the DVI output is HDCP encrypted, then a
HDCP-encrypted source can be selected for
scaling. Note that no other output connector (SDI,
CV, YC, YUV or RGBHV) will function – since they
are not encrypted.
Rep. supprt The repeater unit (e.g. scaler)
attached is capable of HDCP,
but the output is not currently
encrypted. As the DVI output is not HDCP encrypted, then a
HDCP-encrypted source cannot be selected for
scaling.
Rep. active The repeater unit (e .g. scaler)
attached is capable of HDCP,
and the output from the unit is
encrypted. As the DVI output is HDCP encrypted, then a
HDCP-encrypted source can be selected for
scaling. Note that no other output connector (SDI,
CV, YC, YUV or RGBHV) will function – since they
are not encrypted.
Output Adjust Output Adjust
Output type [RGBHV] Output type [RGBHV]
This menu item allows you to select the type of signal output your unit will provide. Types of output vary