Frymaster L.L.C., 8700 Line Avenue 71106, P.O. Box 51000, Shreveport, Louisiana 71135-1000
318-865-1711 FAX 318-862-2394
Printed in the United States
Service Hotline
Page
6
1-800-24-FRYER
Display reads
SET
SET
SET
SET
,
and
LED’s light.
Press
to program the heater plate or
to
program the air heater.
Press the Up and Down Arrow Keys to achieve the desired set-point temperature, then press
the Check Switch once. Both heater LEDs will again light.
Press
or
to get desired setpoint, then press
to lock the temperature in.
If you are finished with programming both heaters, press the Check Switch again to store the
programmed setpoints and exit the programming mode OR to change the setpoint
temperature for the other heater, press the corresponding Heater Switch (1 or 4).
Program as described in Step 4.
When finished, press
again to exit programming
mode. To change the other heater, press
to
program the heater plate or
to program the air
heater, then go to Step 4 for instructions.
7.2 Operation
1. Press the ON/OFF switch to the ON position (the display will light and cycle through an
initialization sequence). The display will read –LO- until the air heater and heater plate are
within 15
°
F of setpoint. It will take approximately 10 minutes for the HLZ to achieve
operating temperature.
