Frymaster L.L.C., 8700 Line Avenue 71106, P.O. Box 51000, Shreveport, Louisiana 71135-1000
318-865-1711 FAX 318-862-2394
Printed in the United States
Service Hotline
Page
12
1-800-24-FRYER
3. Opening the Air Delivery Tower:
a. The air thermocouple and air RTD are
located in the air delivery tower. To
access them, the front air delivery
assembly must be removed.
b. Insert a 5/16” nut driver through the
front air delivery assembly access
holes and turn the nuts
counterclockwise to loosen.
Do not
remove the nuts.
Grab the bottom
flange of the front air delivery, push
upwards and pull towards you. Be
careful, there are two tabs on the front air delivery
bottom that must clear the heater plate to allow
removal of the front air delivery.
4. Replacing Air Thermocouple and Air
RTD Probe:
a. Follow procedures in section 9.3.2 to
access the Air Delivery tower
components.
b. Cut old lead wires close to the faulty air
thermocouple or Air RTD Probe.
Disconnect lead wires at the test plug.
Leave lead wires in place for now.
c. Remove the faulty Air Thermocouple or Air RTD Probe from the bracket.
d. Install the replacement Air Thermocouple or Air RTD Probe into the bracket.
e. Attach the new lead wires to the old lead wires on the Air Thermocouple or Air RTD
Probe on the bracket-side of unit. Grasp the old leads at the test plug and gently pull the
leads towards you.
f. Once the new lead wires have been pulled through, disconnect the old lead wires, and
attach the new leads to the test plug.
g. Go to step 9.3.2 and reassemble the air delivery tower.
Components in the rear tower are
accessed by loosening two nuts,
one under each end of the
overhang.
Air Thermocouple
Air RTD Probe