![Frymaster 17EC Operating Instructions Manual Download Page 7](http://html1.mh-extra.com/html/frymaster/17ec/17ec_operating-instructions-manual_2340331007.webp)
3-7
SELECTING FAHRENHEIT– CELSIUS DISPLAY MODE
1.
The computer can display temperatures in either Fahrenheit or Celsius. To change from one to
the other, press the Program Mode Switch
.
CodE
CodE
CodE
CodE
will appear in the left display.
2.
Enter the code number
1 6 5 8
1 6 5 8
1 6 5 8
1 6 5 8
on the number keypad. The computer will toggle the
temperature display from Celsius to Fahrenheit or from Fahrenheit to Celsius.
3.
Press the Temperature Check/Program Lock Switch
to display the temperature in the newly
selected mode.
SELECTING STANDARD OR SLOW CLOCK
The computer can be programmed for either “standard” or “slow” clock times. The standard clock
displays minutes and seconds, the slow clock displays hours and minutes.
To toggle back and forth between times press the Program Mode
switch, then enter the code
1
1
1
1 6
6
6
6 5
5
5
5 3
3
3
3
using the product buttons.
SELECTING BOIL OR SIMMER MODE
In the
SIMMER
mode, the water temperature is maintained at the setpoint programmed by the op-
erator. In the
BOIL
mode, the water temperature is raised to 212
°
F (100
°
C).
Select the
SIMMER
mode by pressing the
R
button. If the temperature of the water is above the
setpoint,
°-hi
will be displayed. If the temperature of the water is below the setpoint,
°-lo
will be
displayed. If the temperature is within 11°F (6°C) of the setpoint, “
- - - -
” will be displayed.
The
BOIL
mode is selected by pressing the
L
button. The display will show
boil
boil
boil
boil
and the tem-
perature of the water will be raised to 212
°
F (100°C).
3.2.3
Shutting the EWBS with CM III Computer Down
Turn the unit off by pressing the Power
switch.
If shutting down at the end of the day, drain and clean the cookpot, and put the cookpot cover in
place.
CAUTION
The electronic circuitry in your computer can be affected adversely by power fluctuations
and electrical storms. If it fails to function or program properly for no apparent reason, try
unplugging the computer from the interface board and plugging it back in. This could
prevent a service call.