3-4
CAUTION
The Computer Magic III (CM III) computer used in Electric Water Bath Systems is specially
configured for them. The programming and operation of the EWBS CM III are different
than those of the CM III computers used in electric fryers.
The two computers are not interchangeable.
3.2.1
Start-Up Procedure
CAUTION
If this is the first time the unit is being used after installation, refer to
Section 3.4
,
Boil Out
Procedure
.
SETTING THE UNIT UP FOR FIRST-TIME OPERATION
Before turning the cooker on, ensure that:
•
the unit is connected to the water supply.
•
the water supply is turned on.
•
the unit is plugged into an appropriate outlet.
•
the electrical power supply is turned on.
CAUTION
It is recommended that the simmer setpoint and the cook/stir times for
all 10
products be
programmed before the unit is first used in a cooking cycle.
When the unit is tested at the factory, the simmer setpoint and product cook times are programmed.
These
test
settings are
not
default settings. You must program the unit for your own particular prod-
ucts. Program the setpoint and all 10 product cook/stir times as follows:
1.
Turn the computer on by pressing the Power
Switch.
2.
Enter the programming mode by pressing the Program Mode Switch
.
CodE
appears in
the left display. If you enter the programming mode by mistake, press the switch again to
exit the programming mode.
NOTE:
If you try to enter the programming mode while the computer is cooking, the display
will flash
BUSY
.
NOTE:
The unit comes from the factory configured to display in degrees Fahrenheit. To
toggle back and forth between Fahrenheit and Celsius, press the Program Mode
switch,
then enter the code
1
1
1
1 6
6
6
6 5
5
5
5 8
8
8
8
by pressing the corresponding product buttons. Next, press
the Temperature Check/Program Lock
switch to lock in the new display option.
3. Enter the number
1
1
1
1 6
6
6
6 5
5
5
5 0
0
0
0
by pressing the corresponding product buttons. Unless this
code is entered, programming will not be accepted. This is to prevent unauthorized changes
to your current instructions.
