3-3
1.
With the unit in the simmer mode, place the tip of a good grade thermometer near the
temperature probe and determine the actual water temperature in degrees Fahrenheit. If the
temperature is within 5ºF of the desired simmer temperature, nothing more needs to be done. If
it is not within 5ºF of the desired temperature, perform Steps 2 through 5.
2.
With the unit in the simmer mode, open the control panel by removing the screws in the upper
corners and tilting the panel out.
3.
Remove the black rubber plug from the top of the controller housing.
4.
Using a small, flat-tipped screwdriver, turn the adjusting screw to change the simmer setpoint. ¼
turn will change the setpoint about 10ºF. (You will have to experiment with the direction of
rotation to determine which way to turn to raise or lower the temperature.) Wait at least 5
minutes, then recheck actual water temperature. Repeat this step until the water temperature is
within 5ºF of desired temperature.
5.
Replace the plug in the controller, close the control panel, and replace the screws removed in
Step 1.
3.1.4 Shutting the 17EC/17ECS Down
Turn the unit off by pressing the Power
switch. If shutting down at the end of the day, drain and
clean the cookpot, and put the cookpot cover in place.
3.2
Computer Magic III Controller (As Used on EWBS Units)
COMPUTER
MAGIC
L
1
2
3
4
5
6
7
8
9
0
R
1
2
3
2
1
5
4
8
6
7
1
LED Displays
5
Boil Mode Switch
2
Power Switches
6
Product Buttons 1 through 5
3
Temperature Check/Program Lock
7
Product Buttons 6 through 10
4
Program Mode Switch
8
Simmer Mode Switch
