11. SOLUTIONS AND PROBLEMS
PROBLEM
POSIBLE CAUSE
SOLUTION
Is the dryer plugged in ?
The polisher doesn´t work
Plug the dryer into a grounded outlet.
Power switch on?
Turn the power switch on.
The polisher doesn´t work
properly
Are the brushes turning ?
Be sure the machine is plugged and
that the fuse is right. Check also that
brushes are properly fixed.
Is the fan motor working?
With caution put your hand near the exit
of the pipe, checking if there is some
air, and if it is hot.
If there is no air, then the fan motor is
broken; as well, if there is air but it is not
hot, then the heating element would be
the broken piece.
Aren´t you satisfied with the drying?
If you are not happy with the final result
follow these steps :
1 ) Check that there is not rests of grease
in the glasses; in the case it is, wash it
again.
2) Check if the rests you see on the
glasses are from some polishing liquid,
as sometimes dishwashers leave some
rest on the glasses.
3) Check if the brushes are clean; if they
aren´t wash it ( read cleaning instructions
of brushes )
Some operation problems are due to causes that can be solved easily without appealing to the technical
service. Pay attention to the following indications:
12. RECOVERY AND RECYCLING
At the end of its working life, old devices have to be sent back for recovery following each country rules.
We recommend
you to contact with any specialized company in this task or with the waste recoery matters department.
Frucosol has its own individual system of waste management that covers all the National Territory ( Spain).
Frucosol will
take back any equipment manufactured by us within the Spanish territory without any cost for the
customer and will be
sent to the warehouse of Pol. Tejerias C/ Los Huertos Nº26 in Calahorra ( La Rioja)
EN
28