OPERATION
18
MTF--051059L
HOW TO USE THE WHEEL LOCKOUT
Each wheel is secured to the axle with a lockout pin. See
Figure 14. The unit was shipped with the lockout pin in the
locked position. For ease of maneuverability, disconnect the
lockout pin as follows.
1. Pull the
knob
out to disengage the lockout pin.
2. To lock in the disengaged position, turn the
knob
1/4 turn
(90 degrees).
NOTE: Check tire pressure. See side of tire for maximum
inflation. Do not exceed listed maximum pressure.
Figure 14
Knob
Wheel Lockout
HOW TO SET THE DRIFT CUTTERS
(OPTIONAL ACCESSORY ON SOME MODELS)
Drift cutters are used to cut a path through snow deeper than
the auger housing.
1. Loosen the
wingnuts
that secure the
drift cutters
to the
auger housing (see Figure 15).
2. Raise the
drift cutters
to the desired height.
3. Tighten the
wingnuts.
Drift Cutter
Wingnut
Figure 15
HOW TO USE THE HEATED GRIPS
Heated grips are designed for use when the
temperature is below 32 degrees. Do not turn
on electric grips if temperature is above 32 de-
grees.
When the temperature falls below 32 degrees, use the
heated grips to keep your hands warm. Move the
heated grip
switch
to the ON position (see Figure 13). It will take a couple
of minutes for the grips to become warm. Because heated
grips can become very warm, we recommend that you wear
gloves. If you notice that the grips are too warm, turn off
heated grips.
Summary of Contents for ST1332
Page 1: ...ST1332 Snow Thrower MTF 051059L OPERATOR S MANUAL...
Page 38: ...NOTES 38 MTF 051059L...
Page 39: ...NOTES 39 MTF 051059L...
