ASSEMBLY
14
MTF
−
051059L
REMOTE CHUTE CONTROL KNOB
1. Assemble the
remote chute knob
onto the
lever
until
snug against the
nut
(see Figure 8).
2. Make sure
lip
on the
remote chute knob
is pointed to-
ward the engine.
3. Tighten the
nut
against the bottom of the
remote chute
knob.
SPEED SELECT KNOB
1. Thread the knob onto the lever as far as possible. Make
sure that the knob points forward (See Figure 8).
2. Tighten the jam nut against the knob securely.
Figure 8
Remote Chute
Control Knob
Nut
3/8”
Lever
LIp
HOW TO INSTALL
THE SPEED CONTROL ROD
1. Put the
speed select lever
to the NEUTRAL position.
See Figure 9.
2. Attach the
ball joint,
located on the bottom end of the
speed control rod,
to the
shift yoke assembly.
See
Figure 10.
The
fasteners
(washer and nut) are in the
parts bag.
3. The length of the
ball joint
and
speed control rod
have
been pre
−
adjusted at the factory. If an adjustment is re-
quired, loosen the
nut.
Remove the
fasteners
to discon-
nect the
ball joint
from the
shift yoke assembly.
To
lengthen or shorten the
speed control rod,
turn the
adapter
to obtain the correct length.
4. Make sure the
speed select lever
functions correctly.
Move the
speed select lever
through all speeds.
Speed Select Lever
Figure 9
Figure 10
Ball Joint
Speed Control
Rod
Shift Yoke
Assembly
Fasteners
Nut
Adapter
Summary of Contents for ST1332
Page 1: ...ST1332 Snow Thrower MTF 051059L OPERATOR S MANUAL...
Page 38: ...NOTES 38 MTF 051059L...
Page 39: ...NOTES 39 MTF 051059L...
