Frontier FrontierTV, Self-Installation Manual

Page: 6 / 23

6
SET UP
cont.
POWER UP
Approximate time: 15 minutes
• Disconnect the phone cord that is connected to the existing Router’s Phone Lines 1 & 2 port.
• Connect the phone cord to the new Router’s Phone Lines 1 & 2 port.
• Connect the new BBU to the new Router’s power port.
• Plug the new BBU into a standard electrical outlet.
• Turn the power switch on the back of the BBU to the “on” position.
D
PHONES
PHONE LINE
LINES 1
&
2A
U
CAL ETHERNE
T
RESE
T
2
3
PO
WER
4
1
Phone Lines
1 & 2
Phone Lines
1 & 2
Battery Backup Unit
A Voice Line Splitter is
required if you have two
Voice lines.
Your Router is now powering up. During this time, the Broadband
light will turn red and the Power light may turn orange.
Wait up to 15 minutes for the indicator lights for Broadband and
Service to turn solid green and the Local Ethernet indicator light to
start blinking green.
During this time (up to 15 minutes), do NOT unplug
the power cord or the green data cable, as this can
permanently damage the Router AND significantly delay
your service activation.
If the Broadband and Service lights do not turn solid green or
continue to blink after 15 minutes, see the
Having Trouble? section
on page 13 of this guide.
You have successfully completed steps 1 and 2 if the
Router Power, Broadband and Service lights are solid
green. Reboot your receivers by holding down the
power button for ten seconds.
Replacement Wireless Router indicator lights on front
panel. Lights may vary with set up.
Phone 1
Home PNA
Phone 2
Ethernet
Broadband
Service
Wireless
Power