ASSEMBLY
OM 0401-A
16
Figure 6a
Figure 6c
Figure 6b
Figure 6d
Installation of the Cooling Unit 5RDF0036
(Figures 6a to 6g)
For Debris blower working in warm region, use the 5RDF0036 oil cooler. If you own a HP2120 power
unit, use the 5RDF0037 cooling unit upgrade.
IMPORTANT:
To not damage the oil cooler, it is essential to disconnect the fan of the oil cooler
when the temperature is under 0°C.
NOTE:
The new HP2025 and HP2134 pumps are equipped with a safety system to prevent the
hydraulic oil from overheating. When the hydraulic block is not power supplied, the oil is in recirculation
mode meaning that the equipment will not function. To power the block, refer to the Hydraulic Pump
Manual.
1. Figure 6a:
Unscrew the 1 1/16" JIC elbow
(item 1) from the in-tank filter. Remove the
3/4"NC x 2" lg bolt (item 2) and the stover nut
(item 3). Remove the stover nut (item 4) from
the 3/4"NC x 4 1/2" lg bolt but do not remove the
bolt.
2.
Figure 6b:
Unscrew the straight 1-1/16"JIC
adapter (item 1) and rotate the hose of 90
°
up to
bring up the 90
°
1-1/16"JIC elbow adapter
(item 2). Tighten the straight 1-1/16"JIC adapter,
to rotate the hose, at 65-75 ft-lb (93-101 N-M).
3. Figure 6c:
Install the oil cooler support (item 1)
with a 3/4" NC x 2" lg bolt (item 2) and the 3/4"
stover nut (item 3) removed previously. Reinstall
the 3/4" NC stover nut (item 4) previously
removed on the 3/4" NC x 4 1/2" bolt.
4. Figure 6d:
Install the support plates (item 1)
with six 5/16" NC x 1" bolts (item 2), eight 5/16"
flat washers (item 3) and six 5/16" NC nylon
insert nuts (item 4) making sure to place a flat
washer between the support plates and the "U"
section of the frame.
Summary of Contents for BL2130
