TBRA020_REV_A02
© 2020 FRONT RUNNER VEHICLE OUTFITTERS
3
FIT AND SECURE - REAR MOUNT
2
2.1
2.2
2.3
Working underneath and from the rear
of the Rack, Slide two M8 x 16 Hex Bolts
(Item 3) into the second, third, fourth
and
fi
fth Slats of the rack through the
machined slots as shown.
Loosely secure the Table Slides (Item 1
& 2) to the Rack using the M8 x 16 Flat
Washers and M8 Nyloc Nuts (Items 4 &
5) as shown.
Depending on the Width of your Table,
space the two Table Slides 750mm or
550mm apartand tighten all the Nyloc
Nuts and place a M8 Nut Cap (Item 6)
over each Nyloc Nut.
With the Rack still in the upside down
position, cut the T-slot Rubber (Item 8)
to suit the width of your Rack and
insert it into the rear channel of the
fi
rst slat by pinching / squeezing the
sides of the rubber together and
pushing / rolling the Rubber into
channel as shown.
2nd
3rd
4th
5th
Rack shown in
upside down position
Rear Of Rack
750mm or 550mm
