Fronius WF 25i REEL R /SA/2R/G/W, Operating Instructions Manual

Page: 34 / 40

Care, maintenance and disposal
General Under normal operating conditions, the welding system requires only a minimum of care
and maintenance. However, it is vital to observe some important points to ensure the
welding system remains in a usable condition for many years.
Safety
WARNING!
An electric shock can be fatal.
Before opening the device
▶
Turn the mains switch to the "O" position
▶
Unplug the device from the mains
▶
Ensure the device cannot be switched back on
▶
Using a suitable measuring instrument, check to make sure that electrically charged
components (e.g. capacitors) have been discharged
WARNING!
Work that is carried out incorrectly can cause serious injury and damage.
▶
The following activities must only be carried out by trained and qualified personnel.
▶
All instructions in the section headed "Safety rules" must be observed.
Every start-up - Check torch hosepack, interconnecting hosepack and ground earth connection for
signs of damage. Replace any damaged components
- Check feed rollers and inner liners for signs of damage. Replace any damaged com-
ponents
- Check contact pressure of feed rollers and adjust if necessary
- Check that all screw connections between the robot, wire-feed unit mount and wire-
feed unit are secure
- Check all screw joints on system components and associated mounts for tightness
Every 6 months
NOTE!
Risk of damage to electronic components.
Do not bring the air nozzle too close to electronic components.
- Remove the cover from the device and clean the inside with dry reduced com-
pressed air
Disposal Dispose of in accordance with the applicable national and local regulations.
34