![background image](http://html1.mh-extra.com/html/fronius/vr-4040/vr-4040_operating-instructions-manual_2339460030.webp)
30
Pierce the rubber lead-through [H] in the side of the housing
Pull the thermostat cable from the inside of the housing and out through the rubber
lead-through [H]. The Molex plug [M] of the thermostat cable remains inside the hous
-
ing.
Plug the Molex plug [M] onto the heating module, as shown in the circuit diagram
Mount the heating module (4)
Using a threaded bolt, washer and hexagonal nut, mount the temperature sensor in
the drilled hole [D].
Roll up the temperature-sensor cable in a spiral and fasten it to fixing point [Q], togeth
-
er with the thermostat cable.
–
Risk of the temperature sensor dropping out: To prevent this, it is essential to fas
-
ten the temperature-sensor cable to fixing point [P], using cable binders.
Pass the temperature-sensor cable and the thermostat cable through the lead-through
[I].
Cable fasteners: Clip the cable binders into the drilled holes [X]
[A] to [C] ... mount the side guard panel
Heizun
g
Lüfter
Heizung
,
„Extrude-Tite“ screws
(2)
(1)
(3)
1
2
3
4
5
6
7
8
9
Summary of Contents for VR 4040
Page 2: ...2...
Page 4: ...4...
Page 34: ...34 More details on mounting the end of wire watchdog 2 mm...
Page 55: ...55 EN...