![background image](http://html1.mh-extra.com/html/fronius/vr-4040/vr-4040_operating-instructions-manual_2339460012.webp)
12
either radio or television receivers).
If this is the case, then the operator is obliged to take appropriate action to rectify the situ
-
ation.
Check and evaluate the immunity to interference of nearby devices according to national
and international regulations. Examples of equipment that may be susceptible to interfer
-
ence from the device include:
-
Safety devices
-
Power, signal and data transfer lines
-
IT and telecommunications devices
-
Measuring and calibrating devices
Supporting measures for avoidance of EMC problems:
1. Mains supply
-
If electromagnetic interference arises despite correct mains connection, addition
-
al measures are necessary (e.g. use a suitable line filter).
2. Welding power leads
-
must be kept as short as possible
-
must run close together (to avoid EMF problems)
-
must be kept well apart from other leads
3. Equipotential bonding
4. Earthing of the workpiece
-
If necessary, establish an earth connection using suitable capacitors.
5. Shielding, if necessary
-
Shield off other nearby devices
-
Shield off entire welding installation
EMF measures
Electromagnetic fields may pose as yet unknown risks to health:
-
effects on the health of others in the vicinity, e.g. wearers of pacemakers and hearing
aids
-
wearers of pacemakers must seek advice from their doctor before approaching the de
-
vice or any welding that is in progress
-
for safety reasons, keep distances between the welding cables and the welder's head/
torso as large as possible
-
do not carry welding cables and hosepacks over the shoulders or wind them around
any part of the body
Specific hazards
Keep hands, hair, clothing and tools away from moving parts. For example:
-
Fans
-
Cogs
-
Rollers
-
Shafts
-
Wirespools and welding wires
Do not reach into the rotating cogs of the wire drive or into rotating drive components.
Covers and side panels may only be opened/removed while maintenance or repair work is
being carried out.
During operation
-
Ensure that all covers are closed and all side panels are fitted properly.
-
Keep all covers and side panels closed.
The welding wire emerging from the welding torch poses a high risk of injury (piercing of
the hand, injuries to the face and eyes, etc.).
Therefore always keep the welding torch away from the body (devices with wire-feed unit)
and wear suitable protective goggles.
Summary of Contents for VR 4040
Page 2: ...2...
Page 4: ...4...
Page 34: ...34 More details on mounting the end of wire watchdog 2 mm...
Page 55: ...55 EN...