Fronius TransSteel 3000c Pulse, Operating Instructions Manual

Page: 108 / 140

MANUAL
STD SYNERGIC
PULSE SYNERGIC
2T
4T
+
+
2
Parameters for
MIG/MAG syner-
gic welding in
Setup menu 2nd
level
SEt Country-specific setting (Standard/USA) ... Hour/US
Unit:
Setting range: Std, US (Standard/USA)
Factory setting:
Standard version: Std (dimensions: cm / mm)
USA version: US (dimensions: in.)
Syn Synergic programs/characteristics
Standards EN / AWS
Unit:
Setting range: EUr / US
Factory setting:
Standard version: EUr
USA version: US
C-C Cooling unit control
(only when the cooling unit is connected)
Unit:
Setting range: AUt, On, OFF
Factory setting: AUt
AUt:
The cooling unit cuts out after a 2-minute welding off-time.
IMPORTANT! If the coolant temperature and flow monitoring options have been
installed in the cooling unit, the cooling unit cuts out as soon as the return-flow
temperature drops below 50 °C, but at the earliest after a 2-minute welding off-
time.
On:
The cooling unit is always switched on.
OFF:
The cooling unit is always switched off.
IMPORTANT! If the FAC welding parameter is used, the C-C parameter is not
reset to the factory setting. If the MMA welding process is selected, the cooling
unit is always switched off, even if the switch is in the "On" position.
C-t Cooling time
(only when the cooling unit is connected)
Time from when flow monitoring is triggered until the "no | H2O" service code is
output. For example, if there are air bubbles in the cooling system, the cooling
unit will not cut out until the end of this preset time.
108