1. Hold down the up and down arrows at the same time. The panel beeps and the
display shows "rSr". The frame will begin lowering to the lowest level possible.
2. Hold the arrows down again until the panel beeps. The frame will raise slightly,
and the display will show the current height.
Timer settings:
Using the timer, you can set the time after which the frame will automatically go
up.
1. Press the T button. Each time you press it, the remaining time increases by 30
minutes. The maximum setting is 2 hours.
2. After the time is set, the display will flash for a moment, and then return to
displaying the current height. The LED on the panel will come on.
3. After the set time has elapsed, the panel will beep 5 times.
4. To cancel the timer, press the T button several times until the LED goes out.
Panel memory:
You can save a given position (height) of the frame in the panel memory.
1. Press the M button.
2. When the display shows "S-" press a number: 1, 2, or 3.
3. To automatically set the memorized position of the frame, press the number
under which the position was saved.
4. Press any button to stop the adjustment.
Panel Lock:
1. Hold down the M button for 3 seconds.
2. If the panel is locked, the display should read "---". Also, no operation can be
performed using the panel.
3. To unlock, hold the M button again for 3 seconds. The display will show the
current height.
4. The panel locks automatically after 1 minute of inactivity.
Unit change:
