SERVICE MANUAL FS13x_V01-V02-V03-EN08_R2.doc
FROMM
it is forbidden to duplicate this manual or parts of it in any way or any form without written permission of the author © 2017
website: www.fromm-stretch.com
45
ERRORS DURING OPERATION
THE HORSESHOE TURNTABLE DOESN’T START ROTATING
Problem suggestion
Possible solution
-
The machine doesn’t start and generates
an error on the display
- Check if something is blocking the safety-device
of the table
- Check the hidden parameters PA03 should have
the value 3.
- Check the wiring according diagram.
-
The machine doesn’t start and doesn’t
generates an error on the display
- Remove the plate (3) covering the distance
between mast and turntable. (
Fig. 3
)
- Check that 2x rolls (1) are still pressed against
the turtable (2). (
Fig. 1
)
- If you discover a broken roll or excessive wearing
we adivise to replace the rolls.
- Clean the side surface (6) of the table. (
Fig. 1
)
- Increase the tension on the rolls by adjusting the
bolts (4) dont forget to contra block the bolt with
nut (5).
- Higher force on the rolls can give more wearing!!
Fig. 1
Fig. 2
Fig.3
Should the problem persist, contact the Customer After-Sales Service of MANUFACTURER
THE MACHINE DOESN
’T STOP IN THE ZERO POSITION
Problem suggestion
Possible solution
- The machine stops in the wrong position
- The machines has been switched
OFF, not being in the ZERO position.
- Follow below sequence to RESET the
ZERO position.
RE / FIND ZERO POSITON
Press stop and immediate after press reset and hold both buttons for 5
seconds.
The turntable starts to rotate and stops at the next position.
ZERO POSITION CORRECT
– Proceed with working cycle
ZERO POSITION FALSE
– Repeat procedure (Max 3 times)
Should the problem persist, contact the Customer After-Sales Service of MANUFACTURER
4
3
1
5
2
6
