SERVICE MANUAL FS13x_V01-V02-V03-EN08_R2.doc
FROMM
it is forbidden to duplicate this manual or parts of it in any way or any form without written permission of the author © 2017
website: www.fromm-stretch.com
43
ERRORS DURING OPERATION
THE FILM TENSION DOES NOT CHANGE WITH CARRIAGE 2
Problem suggestion
Possible solution
-
Tension on the film to high
-
Clean the friction ring. (1) (
Fig. 2
)
-
Clean the metal brake wheel. (2) (
Fig. 2
)
-
Check the tensioning know (3) (
Fig. 2
)
-
Check the metal sliding plates (4) (
Fig. 2
)
-
Clean the above three mentioned parts
-
Clean the vulcanized roller (4) (
Fig.1
)
-
Film feed in the wrong way
-
Film should be applied before the metal roll (5) (
Fig. 1
)
-
Don’t feed the film between Metal roll and carriage frame
-
Out-feed film is at the LEFTSIDE of roll 5 (
Fig. 1
)
Fig. 1
Fig. 2
THE FILM TENSION DOES NOT CHANGE WITH CARRIAGE 4
Problem suggestion
Possible solution
-
Tension on the film to high
-
Clean the metal disk. (1) (
Fig. 2
)
-
Clean the magnet. (2) (
Fig. 2
)
-
Check the tensioning potential meter (3) (
Fig. 3
)
The higher the value, the higher the brake. Postion 9 values 10
volt.
-
Clean the vulcanized roller (4) (
Fig.1
)
-
Film feed in the wrong way
-
Film should be applied before the metal roll (5) (
Fig. 1
)
-
Don’t feed the film between Metal roll and carriage frame
-
Out-feed film is at the LEFTSIDE of roll 5 (
Fig. 1
)
Fig. 1
Fig. 2
Fig. 3
1
4
4
2
3
5
Leftside
4
1
2
3
5
Leftside
