FRIULAIR PURESTREAM CHILLERS CWE-Q 041, Use And Maintenance Manual

Page: 14 / 44

8
7425MUM753 Model: CWE-Q - Use and Maintenance Manual Rev. 15
3
I
NSTALLATION
3.1 T
RANSPORT
The units are provided with protective corner sections in cardboard and transparent film.
After checking that the packing is undamaged, position the unit near the installation site and
unpack it. The units can be handled using tubes and belts or a forklift truck.
Always keep the chiller vertical: turning it upside down can irreparably damage
several parts of the unit.
Handle with care. Violent falls can cause irreparable damage.
3.1.1 Handling the unit with a forklift truck or pallet jack
The centre of the machine is approximately its centre of gravity. In any case, when
handling the machine with a forklift truck or pallet jack, always check its stability
before lifting.
3.1.2 Lifting with belts and tubes
Base supports that can accommodate bars to raise the units are provided.
Use steel tubes with a diameter of 1¼” and at least 0,12 in//3 mm thick and long enough to
project at least 9.85÷11,81 in//250÷300 mm from both sides of the machine's profile.
Lock the belts so that they won't slip off during lifting (see figure).
3.2 S
TORAGE
Protect the machine from bad weather, even if packed.
Always keep the chiller vertical, even when in storage. Turning it upside down can irreparably
damage several parts of the unit.
If not used, the chiller can be stored packed in an enclosed place, free of dust, with a
maximum temperature of 50 °C/122°F and specific humidity of no higher than 90%.
The packing material is recyclable.
Dispose of each type of material in accordance with the requirements in
the country of use.