Throughput Too Slow for Wireless AC or Wireless N
FRITZ!WLAN Repeater DVB-C
39
check the user interface (see
).
For connections to the wireless access point the FRITZ!WLAN
Repeater applies the encryption method and network key of
the access point. If the connection was established using
WPS, the access point has WPA/WPA2 encryption configured.
Another wireless radio network in the vicinity of the
FRITZ!WLAN Repeater and the wireless access point is caus-
ing interference.
Test a different radio channel. If possible, set automatic radio
channel selection in the wireless access point. Your
FRITZ!WLAN Repeater then will use the same channel auto-
matically.
14.7
Throughput Too Slow for Wireless AC or Wireless N
A wireless device (for instance, a computer) connected with
the FRITZ!WLAN Repeater should use the 802.11ac
(Wireless AC) or 802.11n (Wireless N) standard for high data
transmission speeds. The throughput achieved by this
device, however, is too low for Wireless AC or Wireless N.
In the FRITZ!WLAN Repeater or in the wireless access point an
encryption method other than WPA2 has been configured.
The high transmission speeds of Wireless AC and Wireless N
can be used only with the encryption method WPA2. Enable
WPA2 in the wireless access point and in the FRITZ!WLAN
Repeater.
You can also use Wireless AC and Wireless N in non-encrypt-
ed (open) wireless networks. However, an open wireless radio
network is a security risk. Therefore we strongly recommend
encrypting all wireless networks!
Cause
Help
Cause
Help
