pulverisette 15
page 9
3 Installation
3.1 Unpacking
•
Remove the nails with which the hood is fastened on the
transport pallet. The hood either a wooden box or a cardboard
box placed on the transport pallet.
•
Lift the hood off the transport pallet.
•
Check that the items supplied correspond to your order before
proceeding.
3.2 Transport
•
Transport the machine on the transport pallet using a fork lift
truck or hand fork lift truck.
•
To carry the machine, grip it below at the front and the back.
Carrying the machine will require at least two persons.
3.3 Erection
•
The cutting mill is secured to the transport pallet by four
screws. Undo the four screws.
•
Lift the cutting mill off the transport pallet.
Lifting the machine down will require at least two persons.
Position the cutting mill on
1. a strong table or bench and screw the fixing motor base to the
top so that the collector flange projects over the edge - or
2. screw the cutting mill onto its stand so that it is above the two
feet of the stand.
Please ensure that the machine is fastened securely, as consider-
able transverse forces do occur.
•
Ensure that there is good access to the cutting mill. En-
sure that to the right of the mill, there is sufficient space
for the housing upper section including the funnel to be
opened.
•
Do not block the ventilation louver at the rear. There is a
danger of overheating if the louver is blocked.