1-800-672-4399
Available exclusively at
STEP 2
Lift the front of the top section
as shown, and put the steel door in place
by setting the bottom two rods into the
holes on the bottom section (a). Insert
the top two rods into the holes on the
top section (b).
STEP 5
For airline security purposes only,
insert nylon zip tie (not included) through
hole behind latch and secure tightly.
STEP 3
Make sure the top and bottom
sections are aligned. Secure the top to
the bottom by pushing down the seven
snap latches that are attached to the
top half. If something seems off, make
sure the top and bottom are still aligned
before snapping the remaining latches
shut. Check the latches before each
use to make sure the two halves are
securely attached.
STEP 1
Separate the top section from
the bottom section and loosely place
the top half on the bottom half.
STEP 4
To open the door, squeeze the
two pins together and then pull on the
door while keeping the pins together.
KENNEL ASSEMBLY INSTRUCTIONS
Assembly instructions for kennel models 120133 (X-Small 19-inch) and 120134 (Small 24-inch).
1
3
2
4
(a)
(b)
Plastic Top Section
Plastic Bottom Section
Steel Door
PARTS INCLUDED
4 Bolts
4 Wing Nuts
You will need only 4 bolts
and 4 wing nuts for assembly,
but each assembly packet will
contain additional parts.
wing nut
bolt
5a
5b
