Plug in the unit, then press the “ ” button (when turned on, the unit will operate as the last setting
before shutdown.
To switch the unit off, press “ ” button again, then remove the plug.
Do NOT switch the unit off by removing the plug.
Always switch the unit off by pressing the “ ” button and wait for few minutes before removing the plug.
During Auto, Cool or Fan mode, press the “ ” button to select the desired fan speed. As show below.
During Auto or Cool mode, press the
“
í
” to decrease the set temperature
by 1
ºF or press the
“ + ”
button to increase the set temperature by 1 ºF.
The set temperature can be change in a range of 60 ºF to 90 ºF.
How to Use the Remote Control
TURNING THE UNIT ON
Change fan speed setting
Operating Instructions
Low
Med
Hi
Auto
Change temperature setting
Press the
“
í
”
and
“ + ”
button the same time for more than 3 seconds to switch
between degree Fahrenheit and degrees Celsius.
Note: Under Dry/Fan mode, you can not select C.
°F/°C function
Fault Code
If the screen on the unit displays “P1”, the water
collection tank inside the unit should be full.
Refer to the "Drainage Instructions" on Page
15 for more instructions to drain the
successive condensate. If error repeats,
contact your Authorize Frigidaire Service Center.
If the screen on the unit displays
“ES”, the pipe temperature sensor
has failed. Contact your Authorize
Frigidaire Service Center.
If the screen on the unit displays
“AS”, the room temperature sensor
has failed. Contact your Authorize
Frigidaire Service Center.
If the display reads "E4" , the communication
between display PCB and main control PCB
is faulty. Contact your Authorized Frigidaire
Service Center.
All rights reserved.
©
(OHRPH3URGXFWV,QF
