Wall Sleeve Brands:
#8 White Westinghouse/Frigidaire/
Carrier 52F Series
16
+ 17 ½
Deep
1. If the wall sleeve does not have a rear grille or louvered
panel, install the plastic grille from the kit. The plastic
grille is mounted to the inside of the wall sleeve at the rear
flanges. There are (4) plastic nuts in the flanges of the wall
sleeve. If some are missing replacements are included in
the accessory kit, and can be simply pressed into the square
holes in the flanges. Place the grille against the rear flanges
and use the (4) large washers and screws to secure the grille.
2. Attach (1) 1 ½” x 3/8” x 25” long seal in the center at the top
of the sleeve. Remove the backing paper and press into
position.
3. Attach (2) 1 ½” x 3/8” x 14” seals to the left and right sides
of the sleeve.
4. Attach 1” x ¾” 14” long seal vertically 7” from the left side
of the sleeve.
5. Center unit & gently slide unit into sleeve.
6. Before sliding all-the-way back, remove 2nd screw from front
on left side of unit.
7. Remove the plastic washer from the screw.
8. Screw and attach the other end of the ground wire to the
unit as shown in picture. Make sure that the toothed washer
is against the cabinet.
9. Slide the unit completely to the rear to ensure a good seal,
making sure the ground wire does not become tangled.
10. Seal & Frame the unit as described on the last page of
these instructions.
10
2
4
3
3
k
7
m
