29
CARE AND CLEANING
28
CARE AND CLEANING
Fitting the oven door
• Take hold of the oven door with a hand on each side
and with the door at an angle of 45
o
, position the
recesses at the bottom of the door onto the hinge
arms of the oven. Let the door slide down the hinge
arms as far as it will go.
• Open the door fully to access the hinges.
• Rotate the stirrups (see image below) until they lock
into the hook. The oven door may now be closed.
hook stirrup
hook
stirrup
hook
Cleaning the quad glazed oven door
(FRVEP615 model)
WARNING
CAUTION
Do not lift the door by the handle. Rough handling will
cause glass to break.
Removing the oven door
TIPS & INFORMATION
IMPORTANT
Your oven is equipped with a door that can be
disassembled in order to clean all the panes of glass.
Remove the door before cleaning.
• Open the door fully to access the hinges then rotate
the ‘stirrups’ (highlighted in the image) on both
hinges fully to open position.
• Slowly close the oven door until it is stops against the
‘stirrups’ (about 30°).
• Hold the oven door with a hand each side and
remove it from the oven by pulling it towards you.
CARE AND CLEANING (CONTINUED)
•
Lay the oven door with the outer side facing
downwards on something soft and flat (for example a
blanket on a kitchen table) to prevent scratches.
Removing oven door top trim
• Hold the embossed sections of the door columns
at each end and press inwards to release the clips.
Remove the upper door trim by pulling it
towards you.
Removing the door glass panels
WARNING
CAUTION
Rough handling, especially around the edges can cause
the glass to break.
• Lift the black bordered glass panel out of the
guide and place on something soft and flat to
prevent scratches.
• Repeat this for the smaller clear glass panels.
• When removing panel 3, ensure that the two rubber
spacers are removed before cleaning.
Do not misplace them!
Cleaning the door glass panels
WARNING
CAUTION
Do not use harsh abrasives on the glass panes as the
reflective surface plays a role in the function of the oven.
Do not place glass in dishwasher. Hand wash only with a
soft cloth and warm soapy water. When dry polish with a
soft cloth and ensure the glass is dry before reassembly.
Re-assembling the quad glazed oven door
(on selected models)
Re-assembling the door glass panels
• Assemble the silicone spacers to the upper corners
of one of the clear glass panels. Position the panel
into the lower position of the door, ensuring the
chamfered corner of the panel is placed in the correct
location as shown in the image below.
Chamfer to be located in this corner
Silicone spacers
• Insert the remaining smaller clear glass panel into the
middle position, ensuring the chamfered corner of the
panel is placed in the correct location as shown in the
image below.
Chamfer to be located in this corner
