35
36
When should the batteries be
replaced
1. When there is not a “beep”
anymore from the indoor unit
when using the control remote or
the signal light indicator does not
lit.
2. The indoor unit does not respond
to the remote control commands
to activate the programs.
To replace batteries
1. Slide out the battery
compartment cover ( located in
the back part of the remote
control).
2. Install the two AAA batteries in
the compartment (indicated in the
drawing located inside the
compartment).
3. Slide in the cover.
4. If the remote control is not
operated for long period of times,
batteries should be discarded.
Remote control instructions
1. The signal reach distance of the
remote control to the receiver that
is inside the main unit of the air
conditioner is 8 meters. Any
obstruction placed between the
receiver and the remote control
can cause interference, limiting
the capacity of the programming.
2. Any time that a button is pressed
in the remote control, the air
conditioner emits a “beep” that
indicates that a command has
been received and transmitted in
the indoor unit.
1. When replacing batteries, do not
use old batteries or a different type
battery. This may cause the remote
control to malfunction.
2. If you do not use the remote
controller for several weeks remove
the batteries. Otherwise battery
leakage may damage the remote
controller.
3. The average battery life under
normal use is about 6 months.
4. Replace the batteries when there
is no answering beep from the
indoor unit or if the Transmission
Indicator light fails to light.
3. When selecting the function of
timer, the remote control sends
(automatically) a signal to the
indoor unit at the specific moment.
If the control remote is left in a
position that the signal is blocked,
a 15 minute delay can be
produced.
Remote control description
1
2
3
5
6
ON/OFF:
Push this button to start
the unit operation. Push the button
again to stop the unit operation.
MODE:
Each time you push the
button, a mode is selected in a
sequence that goes from AUTO,
COOL, DRY, HEAT*, and FAN, as
the following figure indicates:
* Note: Only for heating models.
FAN SPEED:
This button is used
for setting Fan Speed in the
sequence that goes from AUTO,
LOW, MED to HIGH, then back to
Auto.
TEMP :
Press the button to
decrease the indoor temperature
setting.
SLEEP:
Press this button to go
into the Energy-Saving operation
mode. Press it again to cancel.
This function is only can be used
on COOL, HEAT and AUTO mode
and maintain the most
comfortable temperature for you.
While the unit is running under
SLEEP operation mode, it would
be canceled if you press the other
button.
TURBO*:
Push this button to
activate/cancel the Turbo function
which enables the unit to reach
4
AUTO COOL
DRY
HEAT*
FAN
Attention
1
2
3
4
5
6
7
8
9
10
11
12
AUTO LOW
MED
HIGH
Summary of Contents for FRS095YC1
Page 28: ...54 53 Notes Notes ...