6
Installation Instructions
10 PREPARATION AND USE OF
THE CARTON TO ASSIST IN
THE INSTALLATION OF THE
MICROWAVE OVEN
Utilization of the carton may make installation easier.
1. Place carton upside down. See Figure 20.
2. Using cutting line around the carton, cut into two pieces (A)
and (B). See Figure 21.
3. Position oven to assist in mounting to the wall.
See Figure 22.
Figure 20
Cutting Line
Top Side
9 OVEN INSTALLATION
cont.
MOUNTING PLATE
1. Separate 4 Toggle Bolts
2
, packed in the INSTALLATION
HARDWARE, from the Toggle Nuts.
2. Match 5/8” holes (not in studs), drilled through WALL TEM-
PLATE into wall to corresponding holes on Mounting Plate.
3. Insert Toggle Bolts into matched openings on Mounting
Plate. Put Toggle Nuts on Toggle Bolts. See Figure 17.
4. Position the Mounting Plate with the Toggle Bolts attached at
the wall location and insert Toggle Nuts and Bolts through
the holes in the wall with the Toggle Nuts closed. Figure 18.
Use Wood Screws
1
to attach the Mounting Plate to studs.
NOTE: Before insertion, be sure you leave a space more
than the thickness of the wall between the Mounting Plate
and the end of each of the Toggle Nuts (in the closed posi-
tion). If you do not leave enough space, the Toggle Nut will
not be able to open on the other side of the wall.
Also, once
a Toggle Nut opens, it cannot be withdrawn from the
hole; therefore make sure all of the Toggles are in the
correct position before insertion.
5. Align the Mounting Plate carefully and hold in position while
tightening Toggle Bolts. Pull Toggle Bolt toward you and turn
clockwise to tighten. Figure 19.
Mounting Plate
Toggle Bolt
Figure 19
Figure 18
Figure 17
Wall
Space
more than
wall thick-
ness
