24
WARNING
ELECTRICAL SHOCK HAZARD
DO NOT make a sharp bend or crimp
wiring/conductor at connections.
9. Follow manufacturer’s guidelines for
firmly securing the strain relief and
power cord.
10. Reinstall the terminal block cover.
Leveling the laundry center
Connecting the water
3. Connect
the
HOT inlet
hose to the
HOT inlet
connection
on the
washer and
the COLD
inlet hose to
the COLD
inlet connection on the washer (cold
on top).
Excessive noise and vibration can be
prevented by properly leveling the
laundry center.
1. With
the
laundry
center within
4 feet (1 m)
of its final
location,
place a level
on top of the washer lid.
3. Press
down
on alternate
corners and
sides and
feel for the
slightest
movement.
Adjust the appropriate leg(s) so the
laundry center sits solidly on the
floor on ALL four legs. Keep the
leveling leg extension at a minimum
for best performance of the washer.
raise
lower
2. Use
adjustable
pliers to
adjust the
leveling
legs so the
laundry
center is
level front-
to-rear and
side-to-side,
and stable corner-to-corner.
1.
Run some water
from the hot and
cold faucets to
flush the water
lines and remove
particles that
might clog the
water valve screens
and to determine
which faucet is hot
and which is cold
supply.
2. Check to ensure
that the inlet hoses
have the rubber
washer firmly in
place. Use only
new hoses.
Í
NOTE
Hoses are not included with laundry
center purchase and must be
purchased separately.
8.
Attach the RED and BLACK power
cord conductors to the outer, BRASS
colored terminals on the terminal
block. Tighten both screws securely.
BLACK or RED
BLACK or RED
power wires
power wires
BRASS
terminals
INSTALLATION
