Frigidaire FKCH17F7HW, Technical & Service Manual

Page: 59 / 63

7-4
Installation Information
Location
1. Choose a place that is near a grounded electrical
outlet. Do Not use an extension cord or an adapter
plug.
2. If possible, place the refrigerator/freezer out of direct
sunlight and away from the range, dishwasher or
other heat sources.
3. The refrigerator/freezer must be installed on a floor
that is level and strong enough to support a fully
loaded refrigerator/freezer.
4. Consider water supply availability for models
equipped with an automatic ice maker.
5. The refrigerator/freezer should be located where
surrounding temperature will not exceed 110ºF
(43ºC) or drop below 10°F (-12°C).
6. For ease of installation, proper air circulation and
electrical connections, see Figure 7-1 for
recommended clearances.
7. For dynamic condenser models, DO NOT block
the toe grille on the lower front of your freezer.
Sufficient air circulation is essential for the proper
operation of your freezer.
NOTE: The exterior walls of the refrigerator/freezer
may become quite warm as the compressor works to
transfer heat from the inside. Temperatures as much as
30°F warmer than room temperatures can be expected.
Leveling
The refrigerator/freezer must have all bottom corners
resting firmly on a solid floor. The floor must be strong
enough to support a fully loaded refrigerator/freezer.
It is VERY IMPORTANT for your refrigerator/freezer to
be level in order to function properly. If the
refrigerator/freezer is not leveled during installation, the
door/lid may be misaligned and not close or seal
properly, causing cooling, frost or moisture problems.
To Level Unit:
After discarding crating screws and wood base, use a
carpenter’s level to level the refrigerator/freezer from
front to back. Adjust the plastic leveling feet in front, ½
bubble higher, so that the door closes easily when left
half way open. (See Figure 7-2)
Figure 7-1. Installation Clearances
Figure 7-2. Leveling Unit