Frigidaire FFPA0822R11 Use & Care Manual Download Page 9

Page: 9 / 14

2009 Electrolux Home Products, Inc.

FAN MODE:

In this mode there is no need to use the exhaust hose or drainage hose.
1. Press the MODE button until the "Fan" indicator lights.

2. Press the FAN SPEED button on the remote control to choose the desired fan speed.

(Fan speed can only be adjusted by using remote control)

3. The fan will run at the selected fan speed and the display will show the room

temperature.

In this mode the exhaust adaptor hose MUST be used.

COOLING MODE:

1. Press the MODE button until the "Cool" indicator lights.

2. Press the " " Temp buttons for desired setting.

3. Press the FAN button on the remote control for desired fan speed.(Fan speed can only

be adjusted by using remote control)

DRY MODE:

In this mode you do not need to use the exhaust adaptor hose, BUT the water

collected must be discharged. See Drainage Section.
1. Press the MODE button until the "Dry" indicator lights.

2. The fan will run at low speed and the display will show the room temperature.

3. Keep doors & windows closed for best effect.

TIMER OPERATION:

Always have the exhaust hose attached in this mode.

AUTO MODE:

When you set the air conditioner in AUTO mode, it will automatically select cooling,

heating(not applicable for cooling only models), or fan only operation depending on what

temperature you have selected and the room temperature. The air conditioner will

control room temperature automatically round the temperature point set by you. Under

AUTO mode, you can not select the fan speed. In the AUTO mode the Cool indicator on

the panel of the unit will light up.(AUTO mode can be only selected by using remote control)

NOTE

Some of the following instruction can only be activated by using remote control.

Operating Instructions

You can set both delay stop and delay start by using the remote control, while unit is in ON

position or OFF position. To set the delay stop timing, first press TIMER OFF button on the

Note: This feature is unavailabe under FAN or DRY modes.

s feature can only be activated by using the remote control.

In this mode the selected temperature will increase by 2 °F 30 minutes after the mode

is selected. The temperature will then increase by another 2 °F after an additional 30

minutes. This new temperature will be maintained for 7 hours before it returns to the

originally selected temperature. This ends the "Sleep" mode and the unit will continue to

operate as originally programmed. The "Sleep" mode program can be cancelled at any

time during operation by again pressing the "Sleep" button.

SLEEP OPERATION:

Fig. 23

remote control to go to delay stop setting, then tap or hold the TIMER OFF button to change
delay stop timer at 0.5 hour increments up to 10 hours, then at 1 hour increments up to 24
hours. After the desired setting is reached stop pressing the TIMER OFF button, the control

will confirm the setting automatically after 5 seconds and change the display back to previous

temperature display. Use the same way as above to set the delay start timing by pressing

TIMER ON button. When the timer function is activated the timer indicator light on the display
of the unit's control panel will illuminated(Fig. 23).
To check the remain timing, press the TIMER ON or TIMER OFF button once. The delay start
operation automatically selects mode, temperature and fan speed are the same as the last
operation you set.To cancel the timer setting, simply tap TIMER ON or TIMER OFF button to
change the timing to 0.0.

Thi

When the sleep function is activated the sleep indicator will light(Fig. 24)

Timer mode indicator

light (set only by remote
controller)

Sleep

indicator

Fig. 24