Frigidaire FASC09F2MBHLW, Instruction Manual

Page: 26 / 29

49 50
Maintenance
Cleaning the indoor unit and remote
controller
1. It is necessary to stop the air
conditioner and disconnect the
power supply before cleaning.
2. Use a dry cloth to wipe the indoor
unit and remote controller.
3. A cloth dampened with cold water
may be used on the indoor unit if it is
very dirty.
4. The front panel of the indoor unit can
be removed and cleaned with water.
Then wipe it with a dry cloth.
5. Do not use a chemically treated cloth
or duster to clean the unit.
6. Do not use benzine, thinner,
polishing powder, or similar solvents
for cleaning. These may cause the
plastic surface to crack or deform.
Cleaning the air filter
A clogged air filter reduces the cooling
efficiency of this unit. Please clean the
filter once every 2 weeks.
1. Lift the indoor unit panel up to an
angle until it stops with a clicking
sound.2. Take hold of the handle of
the air filter and lift it up slightly to
take it out from the filter holder, then
pull it downwards.
3. Remove the air filter (Fresh air
support) of the unit.
4. Remove fresh air filter from frame
support.
5. Clean the fresh air filter at least once
a month, and replace every 4 to 5
months. Use a vacuum cleaner,
filtro de aire
filtro de aire
then dry.
6. Clean the support frame using a
vacuum cleaner or water. After, dry
for a couple of hours or until dry.
7. Insert the fresh air filter in its original
place.
8. Insert the high part of the air filter
(fresh air Support frame)
again in the unit keeping in mind that
the outside border (right and left) are
lined up correctly, now place the
whole filter in the initial position.
Maintenance
If you plan to idle the unit for a long time, perform the following:
1. Operate the fan for about half a day to dry the inside of the unit.
2. Stop the air conditioner and disconnect power. Remove the batteries from
the remote controller.
3. The outdoor unit requires periodic maintenance and cleaning. Do not attempt
to do this yourself. Contact your dealer or servicer.
Checks before operation
1. Check that the wiring is not broken off or disconnected.
2. Check that the air filter is installed
3. Check if the air outlet or inlet is blocked after the air conditioner has not been
used for a long time.
Fig.2
Fig.1
Filtro
refrescante
de aire
Fig.3
Fig.4 Fig.5
Soporte
del marco
Filtro
refrescante
de aire
Filtro
refrescante
de aire
Soporte del marco
Soporte del marco