37
Do not use with water that is
microbiologically unsafe or of unknown
quality without adequate disinfection
before or after the system. Systems
certified for cyst reduction may be used
on disinfected waters that may contain
filterable cysts.
Test & certification results:
• Rated Capacity - 125 gallons/473
liters for
PureSource
Ultra II
TM
ice
and water filter
• Rated service flow - .65 gallons per
minute
• Operating Temp: Min. 33°F, Max.
100°F
• Maximum Rated Pressure - 100
pounds per square inch
• Recommended Minimum Operating
Pressure: 30 pounds per square inch
To replace the PureSource Ultra
II
TM
water filter:
It is not necessary to turn the water
supply off to change the filter. Be ready
to wipe up any small amounts of water
released during the filter replacement.
(Instructional video of procedure can be
found on www.frigidaire.com.)
1. Pull forward and then push down on
front edge of filter cover. Cover will
tilt down and expose water filter.
2. Remove the old filter by rotating it
counter-clockwise (to the left) 90
degrees to release it.
3. Slide the old filter cartridge straight
out of the housing and discard it.
4. Unpackage the new filter cartridge.
Slide it into the filter housing as
far as it will go with the grip end
vertical.
The
PureSource Ultra II
TM
ice and water filter system is
tested and certified to NSF/
ANSI Standards 43, 53 and
401 for the reduction of claims
specified on the performance
data sheet.
More about the Advanced Water
Filter
FILTER REPLACEMENT
5. Push lightly inward on the filter
while rotating it clockwise (to the
right). The filter will then pull itself
inward as it is rotated. Rotate the
filter 90 degrees until it stops and
the grip end is horizontal. A very
light click may be heard as the filter
locks into place.
6. Press a drinking glass against the
water dispenser while checking for
any leaks at the filter housing. Any
spurts and sputters that occur as
the system purges air out of the
dispenser system are normal.
7. Continue dispensing water for
3-4 minutes. It may be necessary
to empty and refill the container
several times.
8. Gallery Models
: To reset, press and
hold the “Reset Water Filter” on
the display for 3 seconds. Tone will
sound once it has been reset.
Pro models
: After replacing filter,
press and hold “Water Filter” on the
display for 3 seconds. Status will
reset to GOOD.
9. Replace filter cover by pushing up
and snapping into place.
