8
QUICK REFERENCE SHEET
Failure codes:
Display shows: F 01
Indicates:
An internal fault in the control.
Correction:
Touch the Stop/Clear pad. If the dis-
play continues to display F 01 or if the
code returns when the dryer is re-
started, replace the control.
Display shows: F 02
Indicates:
Control temperature sensor open or
shorted.
Correction:
Removed the wires from the control
temperature sensor and measure the
resistance of the sensor. If the meter
does not read 50,000 Ohms +/- 10%
replace the sensor. If the meter reading
is within 10% of 50,000 Ohms, check
the wiring between the electronic con-
trol board and the sensor. If the wiring
is good, replace the electronic control
board.
Display shows: F 03
Indicates:
No heat
Correction:
Touch the Stop/Clear pad to clear the
F 03. Program the dry for a NORMAL
CYCLE with HIGH HEAT and touch
START. Measure the voltage drop
across the terminals of relay RL 2 on
the electronic control board. If the meter
reads 240 VAC on electric models or
120 VAC on gas models, replace the
electronic control board. If the meter
reads zero, remove power from the dryer
and disconnect the black wire electric
models and orange wire gas models
from the relay. Reconnect power and
measure the voltage drop between red
wire on the relay RL 2 to neutral. If the
meter reads zero, the wire between the
incoming line and relay RL 2 is open. If
the meter reads 120 VAC, check the
rest of the heating circuit as described
in the trouble shooting section.
Display shows: F 04
Indicates:
The drying time has exceeded the pro-
gram time for that cycle.
Correction:
Touch the Stop/Clear pad. Program the
dry for a NORMAL CYCLE with HIGH
HEAT and touch START. Check for any-
thing that would extend the dry time
such as:
1. Dryer not heating.
2. Restricted vent.
3. Blower fan blade broken or loose.
4. Dryer installed in a closet with a
solid door.
5. Bad connect in sensor bar circuit or
dirty sensor bars.
If the dryer operates normally but the
F 04 code returns, replace the control.
Display shows: F 05
Indicates:
A problem with the key pad.
Correction:
Disconnect the keypad ribbon from the
control and reconnect the ribbon. Try
all keypad switches to see they all func-
tion correctly. If they do not, try clean-
ing the end of the ribbon with a soft cot-
ton cloth. Reinstall the ribbon and pro-
gram the dryer to operate. If the code,
reoccurs replace the touch pad.
Note:
See control removal instruction on
how to disconnect ribbon.
On line test:
To start the test programs, remove power from the dryer.
Reconnect power to the dryer and within 10 seconds
press and hold the temp and the stop pads for at least 2
seconds, then release. The control is now in the test
function.
1.
After activation, the WRINGLE RID icon should be
on.
Summary of Contents for 27" Dryers with electronic controls
Page 32: ...32 UNDER COUNTER STACK MODELS ROUGH IN DIMENSIONS ...
Page 72: ...72 ...
