61
2.
Push up and forward and down and forward on the
rear of the catch moving the catch forward until the
metal tabs hit the front panel.
3.
Release the metal tabs with a small screwdriver and
push the catch out the front.
Removing the door hinge:
1.
Open and support the door.
2.
Remove the two screws holding the hinge to the
front panel and the two screws holding the hinge to
the door.
Removing the door switch:
1.
Disconnect the dryer from electrical supply, open
the door and remove the top.
2.
If the seal is to be replaced open the door and pull
the seal from the liner. If the seal is to be reused,
separate the panels and use a small screwdriver to
push the tabs through the liner.
Removing the door handle:
1.
Separate the panel and release the tabs holding
the handle in outer panel.
Removing the door strike:
1.
Separate the panel, squeeze the ends of the strike
and push it through the inner panel.
Removing the door catch:
1.
Disconnect the dryer from electrical supply,open the
door and remove the top panel.
Summary of Contents for 27" Dryers with electronic controls
Page 32: ...32 UNDER COUNTER STACK MODELS ROUGH IN DIMENSIONS ...
Page 72: ...72 ...
