9
2009 Electrolux Home Products, Inc.
All rights reserved.
Operating Instructions
(continued)
DRAINAGE:
REMOTE CONTROL STORAGE :
During dehumidifying mode, remove the supplied rubber stopper from the
hose connector. Screw a suitable length of hose onto this connector. Place
the open end into a suitable drain, and make sure there are no kinks in the
hose. (Fig.23)
The door on side of the unit is for storing the remote, to open press it as
shown in Fig. 24, to close simply push it back into position.
Continuous
drain hose
Fig. 23
Fig. 24
Remove the
drain plug
SWING OPERATION:
When you turn on the unit, the louver will swing and stop at a certain angle. You
can press the SWING button to let the louver swing automatically. Press the
SWING button again while you want the louver stop at desired angle.
CHECK FILTER FEATURE:
This feature is a reminder to clean the Air Filter (See Care and Cleaning) for more
efficient operation. The LED (light) which above the "Filter" button will illuminate
after 250 hours of operation. To reset after cleaning the filter, press the "Filter"
button and the light will go off.
FAULT CODE:
If the display reads "EA" , the room temperature sensor has failed. Contact your Authorized
Frigidaire Service Center.
If the display reads "ES" , the evaporator temperature sensor has failed. Contact your
Authorized Frigidaire Service Center.
If the display reads "E4" , the display panel communication has failed. Contact your
Authorized Frigidaire Service Center.
If the display reads "P1" , bottom tray is full. Carefully move the unit to a drain location, remove
the bottom drain plug and let the water drain away. Restart the machine until the "P1" symbol
disappears. If error repeats, call for service.
Press here
Operating Instructions
