6
• WHITE KIT • WHITE KIT • WHITE KIT • WHITE KIT • WHITE KIT • WHITE KIT •
- EXCESSIVE WEIGHT HAZARD -
To avoid
back or other injury, have more than one person move or lift
the washer.
C
4
) Attaching washer mounting hardware
3.1 cu ft WASHER INSTRUCTIONS (WHITE KIT)
D
4
) Mounting washer
E
4
) Installing or re-installing washer
Use the following instructions for mounting this type of washer
1.
to the pedestal:
Using two or more persons, slightly tip the washer back and lift it
1.
onto the pedestal. Still tipped, slide the washer back against the
rear brackets and gently set down the front so the appliance is
between the front and rear brackets.
Remove lower service access panel.
2.
Remove 2 lower screws from backsheet of washer. Save screws to
3.
reinstall later.
Attach each front clip to outer-most set of holes with 2 screws.
4.
Adjust the appliance side-to-side to align its mounting holes with
2.
the pedestal’s bracket holes.
Reinstall backsheet screws removed earlier through each rear
3.
bracket into the base of the washer.
Reinstall the lower service access panel.
4.
Reinstall the 2 screws removed earlier
5.
through the outer hole of
each front bracket into the base of the washer.
Slide appliance/pedestal into place.
1.
Check for levelness and rock all four (4) legs again. Repeat until
2.
level and solid.
Refer to
3.
Washer Installation Instructions
for complete details
on installing water, drain, or electrical.
SLIDE BACK
TIP DOWN
middle
slot
outward
Insert “A” tab of each rear bracket into the middle slots on rear
5.
of pedestal. Orient bracket outward for washer mounting.
“A”
tab
Remove 2 screws
from service access
below front panel.
Remove 2 screws from
washer backsheet.
Install 2 screws through each rear bracket into aligning pedestal
6.
holes.
