13
General installation
Grounding type
Grounding type
wa
wall receptacl
ll receptacle
Po
Power cord with
wer cord with
3-prong
3-prong gr
grounded plug
ounded plug
Do not,
Do not, under
under
an
any cir
y circumstances,
cumstances,
cut,
cut, remo
remove
ve,
or b
or bypass th
ypass the
gr
grounding pr
ounding prong.
ong.
Connect the exhaust duct to the outside exhaust system
1.
(see pages 4 through 6). Use of a 4” (10.2 cm) clamp (item
A) is recommended to connect the dryer to the exhaust
vent system. Use metal foil tape to seal all other joints.
Carefully slide the dryer to its fi nal position. Adjust one or
2.
more of the legs until the dryer is resting solidly on all four
legs. Place a level on top of the dryer. The dryer MUST be
level and resting solidly on all four legs. Rock alternating
corners to check for stability. Remove and discard door
tape.
Plug the power cord into a grounded outlet.
3.
Turn on the power at the circuit breaker/fuse box.
4.
Read the
5.
Use & Care Guide
provided with the dryer. It
contains valuable and helpful information that will save
you time and money.
If you have any questions during initial operation, please
6.
review the “Avoid Service Checklist” in your
Use & Care
Guide
before calling for service.
Place these instructions in a location near the dryer for
7.
future reference.
Be sure the power is off at a circuit breaker/
fuse box before plugging the power cord into an outlet.
A wiring diagram and technical data sheet are
located inside the dryer console.
A
Summary of Contents for 137111800B
Page 32: ......
